User manual

1. Pull out the spring split pin [A] of the safety bolt [11] and fold the xing [B] at the max‐
imum angle in the opposite direction to pull the safety bolt out of the square tube [7].
2. Loosen the safety screw [6] on the tube clamp of the main tube [3] and crank the square
tube [7] all the way down with the crank [8]. Fix the position of the square tube with the
safety screw [6].
3. Pull out the spring split pin [A] of the safety bolt [12] and fold the xing [B] at the max‐
imum angle in the opposite direction to pull the safety bolt out of the upper extension
tube [5].
4. Loosen the safety screw [4] on the tube clamp of the square tube [7] and crank the upper
extension tube [5] all the way down with the crank [8]. Fix the position of the extension
tube with the safety screw [4].
5. Remove the spotlights. During the assembly, pay attention to an even weight distribu‐
tion to reach a centric load of the tripod.
6. Loosen the safety screw of the mounting and detach the cross beam.
7. Pull out the spring split pin [A] of the safety bolt [10] and fold the xing [B] at the max‐
imum angle in the opposite direction to pull the safety bolt out of the main tube [3].
8. Loosen the safety screw [1] on the lower slide, to which the four cross struts are
attached, and fold up the feet of the tripod [2].
9. Pack all parts of the system in their original package, as possible, and store the package
in a dry place protected against moisture.
Dismounting
Operating
Wind Up 100-4
15
Lighting Stand