User manual

3. Flange the cross beam onto the mount for the cross beam at the tripod top end [9] and
tighten the securing screw of the mount. Attach the spotlights. Pay attention to an even
weight distribution to reach a centric load of the stand. The maximum load capacity of
110 kg in total must not be exceeded.
4. Loosen the locking screw [4] on the tube clamp of the square tube [7].
5. Crank the upper extension tube [5] clockwise with the crank [8] until the safety bolt [12]
engages in the desired position in the upper extension tube [5]. Fix the position of the
extension tube with the safety screw [4] on the tube clamp of the square tube [7].
6. Loosen the locking screw [6] on the tube clamp of the main tube [3].
7. Crank out the square tube [7] clockwise with the crank [8] until the safety bolt [11]
engages in the desired position in the square tube [7]. Fix the position of the square tube
with the safety screw [6] on the tube clamp of the main tube [3].
8. Turn the crank [8] slightly counter-clockwise to avoid over-tensioning the wire rope.
Operating
14
Wind Up 100-4
Lighting Stand