Assembly instructions

Table Of Contents

TM-X Laptop Holder (item no. 540269)

Loosen the locking screw and place the laptop holder in the recess of the TM-X Arm (item no. 540250, 540252, 540254). Tighten the

locking screw.

For adjusting the laptop holder tilt, loosen the Allen screws using an Allen key. Adjust the desired tilt and tighten the Allen screws

using an Allen key.

For adjusting the clamping range of the laptop holder, pull out the lateral clamping jaws at the sides of the the laptop holder. Make

sure that the laptop sits rmly between the clamping jaws.

Installation

TM-X

Desktop Stand