Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 522448_20.09.2021
Keyboard Stand Z
EN
Quick start guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include
this quick start guide.
Safety instructions
Intended use
This device is used as a secure keyboard stand. Any other use or use under other
operating conditions is considered to be improper and may result in personal in-
jury or property damage. No liability will be assumed for damages resulting from
improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and
are not within reach of babies and young children. Choking hazard! En-
sure that children do not detach any small parts (e.g. knobs or the like)
from the unit. They could swallow the pieces and choke! Never let unat-
tended children use electrical devices.
Where to use the product
Never use the product
• in direct sunlight
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
• near magnetic elds
General handling
• To prevent damage, never use force when operating the switches and controls.
• Never immerse the appliance in water. Just wipe it with a clean dry cloth. Do not
use liquid cleaners such as benzene, thinners or ammable cleaning agents.
Features
• Stand for one keyboard
• Z shape
• Height adjustable in steps: 635–930mm
• Width adjustable in steps: 630–930mm
• Support depth: 450mm
• Max. load capacity: 50kg
• Transport dimensions (L×W×H): 620×740×200mm
• Weight: 10kg
Setup & adjustment
1. Unfold the upper and lower support arms of both side panels from the
centre support until both support arms audibly click into place.
2. Screw the cross brace with the screws r and the washers e to both side panels.
3. To adjust the height of the keyboard stand, loosen the screw w on both side
panels. Pull the supports out of both side panels so that the desired total height
is achieved. Then tighten the screws w again.
4. To adjust the width of the keyboard stand, loosen the screw t. Pull the support
out of the cross brace so that the desired overall width is achieved. Then
re-tighten the screw t.
5. To be able to fold in the upper and lower support arms for transport, rst pull
on the rings u to unlock the catches for the support arms.
q Left side panel
w Hand screw for height adjustment
e Washer
r Hand screws for fastening the cross brace
t Hand screw for width adjustment
y Right side panel
u Ring for unlocking the support arm catches
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected for recy-
cling. Please follow the notes and markings on the packaging.
Possible staining
The plasticiser contained in the rubber feet of this product may possibly react with the
coating of your parquet, linoleum, laminate or PVC oor and after some time cause
permanent dark stains. In case of doubt, do not put the rubber feet directly on the
oor, but use felt-pad oor protectors or a carpet.