Instruction manual

Zone 2 is set to on.
Height 2 Left
Default Value: 9.0ft/2.70m
Specify the distance between each speaker and the listening position.
This setting cannot be changed in any of the following cases.
– "Speaker Settings" - "Height 2 Speakers Type" is set to "Not
Use".
– "Speaker Settings" - "Front Speakers Type" is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is set to "Yes" and also
Zone 2 is set to on.
When the speaker is set to "None" in "Speaker Configuration", the
settings for "Speaker Distance" cannot be changed.
Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are
automatically configured if you use the Automatic Speaker Setup.
Front Left
Default Value: 0.0dB
Select a value between "-12.0dB" to "+12.0dB" (in 0.5dB increments). A
test tone will be output each time you change the value. Select the
desired level.
Wide Left
Default Value: 0.0dB
Select a value between "-12.0dB" to "+12.0dB". (in 0.5dB increments) A
test tone will be output each time you change the value. Select the
desired level.
This setting cannot be changed in any of the following cases.
– "Speaker Settings" - "Front Speakers Type" is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is set to "Yes".
Center
Default Value: 0.0dB
Select a value between "-12.0dB" to "+12.0dB". (in 0.5dB increments) A
test tone will be output each time you change the value. Select the