Instruction manual

The display is dark
Make sure that Dimmer function is not working. Press DIMMER button
and change the brightness level of the display.
The following settings can be made for the component video and
composite video inputs.
While holding down the input selector button to configure, press HOME
once at a time until “Video ATT:On” appears on the display. To resume
the setup, repeat the above described step until “Video ATT:Off” appears
on the display.
This setting is possible for input selectors assigned with one of the video
inputs "VIDEO 1" to "VIDEO 3" in "1.Input/Output Assign" - "Component
Video Input" or "Composite Video Input". If you have a game console
connected to the composite video input, and the picture is not very clear,
you can attenuate the gain.
Video ATT: Off: (Default).
Video ATT: On: (Gain is reduced by 2dB.)
The picture on your TV/monitor connected to the HDMI output(s) is
unstable
Try turning the DeepColor function off.
To turn off the DeepColor function, press STB/DVR and ON/STANDBY
on the AV receiver simultaneously.
While holding down STB/DVR, press ON/STANDBY repeatedly until
“Deep Color:Off” is appeared on the display. To reactivate the DeepColor
function, repeat the above described step until “Deep Color:On” appears
on the display.
The AV receiver contains a microPC for signal processing and control
functions. In very rare situations, severe interference, noise from an external
source, or static electricity may cause it to lockup. In the unlikely event that
this happens, unplug the power cord from the wall outlet, wait at least 5
seconds, and then plug it back in.
Onkyo is not responsible for damages (such as CD rental fees) due to
unsuccessful recordings caused by the unit’s malfunction.
Before you record important data, make sure that the material will be
recorded correctly.
Before disconnecting the power cord from the wall outlet, set the AV receiver
to standby.