Instruction manual

"Off": The function is disabled.
If the input is not switched automatically, set to "Off" and change the
input manually.
Auto Reconnect
Default Value: On
This function automatically reconnects to the Bluetooth-enabled device
connected last when you change the input selector to "BLUETOOTH".
"On": Use this function
"Off": Do not use this function
This function may not work depending on your Bluetooth-enabled
device.
Wakeup via Bluetooth
Default Value: Off
This function wakes up the unit on standby by connecting a Bluetooth-
enabled device.
"On": Use this function
"Off": Do not use this function
Setting to "On" increases the power consumption even when the unit
is on standby. However, the increase in power consumption is kept
to a minimum by automatically entering the HYBRID STANDBY
mode, where only the essential circuit is operating.
This setting "Wakeup via Bluetooth" is fixed to "Off" if "Direct
Change" is set to "Off".
Pairing Information
Default Value: –
When paring is performed, the information of the previous pairing
stored in this unit will be initialized.
Pressing ENTER when "Clear" is displayed initializes the pairing
information stored in this unit.
This function does not initialize the pairing information on the
Bluetooth-enabled device. When pairing the unit again with the
device, be sure to clear the pairing information on the Bluetooth-
enabled device in advance. For information on how to clear the
pairing information, refer to the Bluetooth-enabled device's
instruction manual.
Device