Instruction manual

"BD/DVD", "CBL/SAT", "STB/DVR", "GAME", "PC", "AUX", "TV/CD",
"PHONO": Video of the device connected to the HDMI IN jack assigned
to each input will be displayed on the TV.
"Last": Video of the device connected to the HDMI IN jack assigned to
the input selector that was selected immediately before the unit enters
standby mode will be displayed on the TV.
"Auto": Video of all the devices connected to the HDMI IN jacks will be
output to the TV.
"Auto(Eco)": Video of all the devices connected to the HDMI IN jacks
will be output to the TV. If you select this setting when using a CEC-
compatible TV, you can reduce the power consumption in standby
mode.
In the following cases, the "Auto" and "Auto(Eco)" cannot be
selected:
– "HDMI CEC (RIHD)" is set to "Off".
– "HDMI CEC (RIHD)" is set to "On" and also "Control Monitor" is
set to "ZONE2".
When "HDMI Through" is enabled, the power consumption
increases even when the unit is on standby. However, the increase
in power consumption is kept to a minimum by automatically
entering the HYBRID STANDBY mode, where only the essential
circuit is operating.
When changing the setting, turn off and then on again the power of
all connected components.
Audio TV Out (MAIN)
Default Value: Off
You can enjoy audio through the speakers of the HDMI connected TV
while this unit is on.
"On": Use this function
"Off": Do not use this function
If you select "On", set "HDMI CEC (RIHD)" to "Off."
The setting is fixed to "Auto" if "HDMI CEC (RIHD)" is set to "On"
and "Control Monitor" is set to "MAIN".
Listening mode cannot be changed if "Audio TV Out (MAIN)" is set
to "On" and audio is being output through the speakers of the TV.
Depending on your TV set or input signal of the component, audio
may not output through the speakers of the TV even if this setting is
set to "On". In such case, audio is output from the speakers of the
unit.
If you operate the MASTER VOLUME control of the unit when
"Audio TV Out (MAIN)" or "HDMI CEC (RIHD)" is set to "On" and
you are listening to the audio through the speakers of your TV, audio
will be output from the unit. If you do not want to output audio from
the unit, change the unit or TV settings, or reduce the volume of the