Installation guide

RoadRunner Installation Guide
Main Power Connections
1331-118th Ave SE, Ste 300 - Bellevue, WA 98005
Tel: [phone] / Fax: [phone]
www.avt-usa.com
Page 6
Main Power Input
Yellow to Ignition
If connecting to ignition switch,
use blue connector to tap
ignition wire.
Red to Positive
Black to Negative
Red Power Wire
Install supplied
10 amp fuse
CAUTION:
If connecting to fuse block,
connect ONLY to ignition fuse
Install supplied
1 amp fuse
before ignition
switch
If available, use 24 VDC bus power (filtered on-board power not necessary)