Owner's Manual

3. S/RF/CAL/SWR Meter: Displays Transmit/Receive signal strength,
RF Power, and SWR usage. Calibrate SWR transmission power
usage.
4. Channel Number display.
5. Operation keys and associated LEDs:
■ Talkback:Talkback lets you monitor yourself when transmitting.
Press Talkbackto activate the function (LED= on). With Talkback
active, press
PTT and adjust the volume with the Channel
Selector/MENU/OKknob.
(Levels 00- 15, LED= RED)
■ MIC Gain: Press MIC Gain key to turn on MIC Gain and adjust
microphone sensitivity for transmission. Delivers up to 100%
modulation. With MIC Gain active, press PTT and adjust the gain
levels
with the Channel Selector/MENU/OKknob. There are four
levels [Low Gain/00 - High Gain/04 (LED= RED)]. If no PTT or
Wireless PTT action after 5 seconds, MIC Gain turns off. Press MIC
Gain switch again
to turn off.
NOTE: If Talkback is on when MIC Gain is also on, Talkback
volume
increases.
■ VOX: Press to turn VOX on and off. Press and hold to enter and
exit
the VOX menu (LED= RED).
■ BLUETOOTH:Press for 2 seconds to turn Bluetooth on and off.
Press for 4 seconds to enter Pairing mode. (LED= RED, BLUE
6. Channel Selector/MENU/OK Press the inner MENU/OK key to
select a menu option or other selection. Turn the outer Channel
Selector
knob to:
■ Select channels (Clockwise to increase from 1 - 40;
counterclockwise
to decrease from 40 - 1)
■ Select menu modes
■ Change scan direction (up or down)
■ Resume scanning from Scan Stay
■ Control Talkback volume
■ Control Mic Gain level
■ Control Calibration volume
NOTE: All channels except Channel 9 may be used for normal
communication. The FCC reserves Channel 9 for emergencies
involving the immediate safety of individuals or protection of
8