Owner's Manual

FIRST TIME PAIRING CONNECTION TO THE RKCBBT AND A
PHONE USING THE SUPPLIED RKING940 HEADSET OR
A CUSTOMER OWNED HEADSET WITH A BLUETOOTH®
VERSION OF 5.0 OR HIGHER.
NOTE:
• The supplied RKING940 and wireless PTT are already paired to the
supplied RKCBBT radio.
1. Turn off the RKCBBT.
2. Turn off the RKING940.
3. Turn off BLUETOOTH® function on the phone.
4. Press and hold the multi-function button on the RKING940 headset until the
headset says "pairing mode': the LED on headset will blink red/blue.
5. Turn on the BLUETOOTH® function on the phone and look for the RKING940,
select the RKING940 to connect it to your phone. If asked, enter the code "0000"
or "8888': The headset will give the voice
prompt "connected':
6. Confirm connection to the phone by placing a call or some other means.
7. Turn on the RKCBBT.
8. Press the BLUETOOTH® button on the RKCBBT radio. After 5 to 20 seconds the
headset will say "connected':
9. The RKCBBT BLUETOOTH® LED will flash "red':
10. Turn on the VOX function by pressing the VOX button on the RKCBBT (the LED
will light red) and speak into the RKING940 headset mic to confirm connection.
You will see the S/RF meter on the RKCBBT screen rise indicating a broadcast. At
this point, Wireless-PTT is not yet paired, so Headset works with VOX only.