Owner's Manual

DO NOT RETURN THIS RADIO TO THE STORE
WITHOUT CALLING TECHNICAL SUPPORT FIRST.
Your new RKCBBT radio is ready to use "out of the box" and is paired with the
included RKING940 headset and wireless PTT . However, if you wish to use your own
headset or connect the included RKING940 to a phone also, there are procedures
that need to be followed in a specific order for the unit to operate as designed
and intended. Please select your preferred operating situation below and follow
the instructions very carefully. It is recommended that you read the included user
manual before operation to understand and get the best experience from your
radio and headset. Before starting the set up for the BLUETOOTH® headset make
sure the RKCBBT is properly installed and the SWRs have been tuned using the
hand held mic. Instructions on how to set the SWR is on page 23 of the manual.
USING THE RKCBBT AND THE SUPPLIED RKING94O
WITHOUT PAIRING TO A PHONE (you can always add one later)
1. Turn on the RKCBBT.
2. Press the BT button on the radio momentarily till the LED blinks RED once, when
you let go it will start blinking BLUE
3. Press and hold the multi-function button on the RKING940 headset until the
voice prompt says "power on':
4. The headset will automatically connect to the RKCBBT and the voice prompt will
say "connected': (It may take 1 Oto 60 seconds for the RKCBBT and the RKING940
to connect.)
5. Turn on the VOX function by pressing the VOX button on the RKCBBT (the LED will
light red) and speak into the RKING940 mic to confirm connection. You will see
the S/RF meter on the RKCBBT screen rise indicating a broadcast. At this point,
Wireless-PTT is not yet paired, so Headset works with VOX only.