Owner's Manual

continually broadcasts weather conditions when you are in Weather
mode.
1. Press CB/PA/W>qWXALTuntil WX icon displays.
2. Rotate the Channel Selector knob to cycle through the 7 weather
channels. Press the knob to select that WX channel. The channel
number displays in the channel number area (1 - 7) and that
frequency displays in the frequency block .
NOTE: When in WX mode, AN/NB, Talkback, MIC GAIN, SRF/
CAL/SWR,
and VOX options are not accepted. An error tone
sounds if attempted.
NOTE: You cannot change ANL or NB settings while in WX
mode. The radio will sound an alert tone.
Set
Weather Scan Mode
Weather Scan mode allows the radio to move to the next weather
channel
if no signal is detected after 3 seconds. Set Weather Scan mode
to ON or OFF through the menus.
1. Press MENU/OK to activate the menus. D-COLOR displays.
2. Turn the Channel Selector knob to cycle through the menu
options until WXSCAN displays.
3. Press MENU/OK ON displays.
4. Press MENU/OK to set Weather Scan mode to ON or turn the
selection knob until OFF displays and then press MENU/OK to
set it. WXSCAN displays again.
NOTE: If Weather Scan is ON when you turn on radio,
it remains ON.
Left at these setting (WX mode, WX Scan), you will hear only weather
broadcasts and Weather Alert signals.
To use your CB radio normally
while monitoring weather alerts,
press WEATHER again.
Set Weather Alert Mode
Weather Alert mode only operates when you are in CB and PA modes; it
does not operate in Weather mode. In CB and PA modes, the radio sounds
an alert tone when it detects a 1 OSOHz tone on a weather channel.
19