Owner's Manual

2. Pair to Bluetooth-enabled device.
NOTE: When pairing, stay within range of the Bluetooth-
enabled device you are pairing
to (no more than 3 feet away).
• Verify that the headset is turned off.
•
Hold the ON/OFF key for approximately 5 seconds. Power On
sounds
and the status light flashes between RED and BLUE.
• Find the Bluetooth settings and search for your headset on
the device list. Select RKING940.
• If requirerd, enter PIN code 0000 and confirm.
• If pairing is successful, the voice prompt "Connected" sounds
and the status LED turns BLUE for 1 second.
Setting Up Wireless PTT
The Wireless PTT coordinates with the Bluetooth headset to provide a
simple method
is a wireless device that wraps around a finger (usully the
index finger) with a hook and loop tape closure. It has a PTT key in the
center of the front face that can be pressed to talk (see page 10).
There
is no ON/OFF key or switch for the wireless PTT key. It is always
ON
until the battery level drops. When it drops, the status LED flashes
when the PTT key is pressed.
Pairing Wireless PTT to Bluetooth Headset
1. Power off the RKCBBT unit, then power it back on. If Bluetooth is
on, turn it off.
2. Press and hold BLUETOOTH for 4 seconds. The CB enters pairing
mode and the blue and red Bluetooth LEDs blink.
3. Place the headset in pairing mode. See "Pair to Bluetooth-Enabled
Device"
operation in previous section. When paired to the
headset, the CB Bluetooth LED is solid Red.
4.
Press and hold the wireless PTT's PTT key. When pairing is
complete, the Bluetooth LED is solid blue.
OPERATING MODES
There are three operating modes:
■ CB (including VOX mode)
15