Owner's Manual
Table Of Contents
- Owner's Manual
- CB Radio Quick Start Guide
- CB Radio Service Rules
- Headset Owner's Guide
- NOTICE BEFORE USING
- SPECIFICATIONS
- PACKAGE CONTENTS LIST
- RKING940 BLUETOOTH® HEADSET OVERVIEW
- BATTERY INFORMATION
- CHARGING THE BATTERY
- PAIR TO YOUR BLUETOOTH® ENABLED DEVICE
- MUL Tl-CONNECTION FUNCTION
- TURNING HEADSET ON/OFF
- WEARING YOUR HEADSET
- USING RKING940
- RESET RKING940
- SAFETY AND GENERAL INFORMATION
- FCC & IC STATEMENT
- WARRANTY
- Warranty
Power Cord Connection
RoadKing recommends connecting the power lead
to
the Ignition Switch
Accessory Terminal. This way, the transceiver
is
automatically turned
off
when the ignition switch
is
turned off.
As
an
alternative,
the
power cord may be connected
to
an
available
terminal on
the
fuse block or
to
a
point
in the wiring harness. However,
caution must be taken
to
prevent a short circuit.
If
in doubt, contact your
vehicle dealer for information.
Ground Information
NOTE: This transceiver
may
be
installed
and
used in
any
12-volt
DC negative
ground
system vehicle.
Negative
Ground System
With a negative ground system, the negative(-) battery terminal
is
usually connected
to
the vehicle
motor
block.
OR
Connect the red
DC
power cord from the
transceiver
to
the
positive(+) battery terminal
or other convenient point. Then connect the
chassis
black power cord
to
the vehicle
chassis
or negative(-) battery terminal.
MARINE INSTALLATION
Consult your dealer for information regarding marine installation.
It
is
important
to
adequately ground the system and
to
prevent electrolysis
between the fittings in
the
hull and the water.
12