User's Manual

30
If there are obstacles in front of the vehicle, and the lane line and the distant skyline cannot be seen, the
installer can also use the calibration rod to calibrate.
Step 1: prepare a calibration rod whose length exceeds the installation height of the camera and stand it 1.5
meters in front of the camera;
Step 2: measure the installation height of the camera with a tape measure, and mark the same position of
the calibration rod with an obvious color;
Step 3: enter the ADAS calibration page, adjust the up and down angle of the camera through the real-time
video image until the mark on the calibration bar coincides with the horizontal line of the screen, as shown
in the following figure:
Step 4: measure the height of the camera from the ground, the distance of the camera from the center line,
the width of the vehicle, and the distance from the camera to the front bumper with a tape measure, modify
the parameters according to the actual situation, click the Save button, and exit after hearing the "calibration
completed" language prompt.
9.4.2.
BSD Calibration
Click“Algorithm Setting” ， Enter the algorithm configuration page to calibrate BSD camera. Select the
installation type and camera type according to the installation requirements, and click "install manual" to
view the corresponding installation instructions. After operating according to the install manual, click
"calibrate" to calibrate the BSD.