User's Manual

22
Figure 12
：
Adjust the angle
Figure 13
：
Make sure the skyline is in the center of the screen or in web-app
8.3.3.
Wiring and precautions
When wiring, pay attention to put the harness into the gap between the windshield and the center console
as far as possible to hide the harness; Before fixing the camera, check whether the camera is clean. If there
are fingerprints or dirt, please gently wipe it with a soft cleaning cloth. Gently press the camera until the 3M
adhesive tape and windshield are fully bonded, ensure that camera is stable.
8.4. I
NSTALL
BSD C
AMERA
（T
AKE TRUCK AS AN EXAMPLE
）
8.4.1.
Installation position requirements
There are generally three installation schemes (installation positions) for BSD cameras. Type1 is generally
recommended for trucks, and Type2 and type3 can be selected according to the actual project situation. For
specific installation and calibration methods, see web app - algorithm configuration. This document takes
type1 as an example to explain the installation and calibration of BSD.
The best effect is when the installation height of BSD camera is about 1.8m from the ground. If there is no
installation position at 1.8m, the height can be selected between 1.8m and 2.2m. When selecting the front
and rear positions, try to stay back and be more than 2 meters away from the middle axle of the vehicle, as
shown in Figure 14 below.