Troubleshooting guide

70
C. MANUAL LOADING RAMPS
Funmovers without liftgates have two steel loading ramps designed to hook onto the
end of the cargo area to enable loading and unloading of your equipment.
To use these ramps:
1. Pull down on the rubber release latch (there is one on both the left and right side
of the bumper).
2. Unlock the padlocks on both sides.
3. Swing the steel cover plates up and attach to the black plastic “hook”.
4. CAREFULLY lift the loading ramps out and hook onto the steel catch at the end of
the cargo area, being extremely careful not to catch fingers, or hands between the
ramp and the steel catch.
5. Check the weight rating on the sticker in the cargo area for the ramp’s maximum
capacity.
6. Reverse this procedure to replace the ramps and travel.
7. NEVER move the motorhome with the loading ramps in their load position.
8. Always shut the fuel supply to carried vehicles off once they are loaded.
9. Always keep the cargo area ventilated.
D. LIFTGATE REMOTE CONTROL
The liftgate remote control is located in a pocket near the main entry door. Plug
the cord to the remote control into the socket on the bottom corner of the right
side of the Funmover.
You must store the remote control and the cord in it’s proper compartment to
ensure that it will not be lost or damaged. Do not allow the cord to be caught in
the liftgate or allow it to lay on top of the support chains, as this will damage the
cord. You are responsible for all damage to this remote control and cord.