Installation guide

RO-MAN REVERSE OSMOSIS SYSTEM INSTALLATION GUIDE
5
T
HE MEMBRANE HAS A PLASTIC CORE IN THE CENTER OF THE MEMBRANE MATERIAL. YOU WILL SEE THERE
ARE TWO SMALL BLACK O
-RINGS. HOLDING THE HOUSING INSERT THE MEMBRANE WITH THE TWO SMALL,
BLACK O
-RINGS FIRST, IT WILL STOP AT THE LARGE BLACK GASKET SEAL LOCATED ON THE OUTER EDGE
OF THE MEMBRANE MATERIAL
. PUSH THE MEMBRANE INTO THE HOUSING SOMETIMES IT’S A TIGHT FIT SO
PUSH WITH ADEQUATE FORCE
. YOU WILL FEEL IT “SEAT” INTO THE HOUSING.
O
NCE THE MEMBRANE IS SEATED PROPERLY, MAKE SURE THE HOUSING “O RING” IS FITTED AND MOIST.
THEN SCREW THE HOUSING CAP ONTO THE HOUSING AND RE
-ATTACH THE GREEN TUBE/S AS BEFORE.
R
EPEAT THE ABOVE IF YOUR SYSTEM HAS A SECOND/THIRD MEMBRANE (200 AND 300 GALLON SYSTEMS)
F
ITTING THE PIPES TO FLUSH THE CARBON FILTERS (YOU COULD DAMAGE THE MEMBRANE IF YOU DO
NOT DO THIS
)
RO-MAN.COM LTD Page 5 of 15