Installation guide

RO-MAN REVERSE OSMOSIS SYSTEM INSTALLATION GUIDE

RO-MAN.COM LTD Page 3 of 15

STARTING YOUR INSTALLATION

PREPARATION

ETERMINE THE LOCATION FOR THE INSTALLATION OF THE SYSTEM. AVOID LOCATIONS WHERE THE

SYSTEM MIGHT COME IN CONTACT WITH HOT WATER PIPES OR OTHER HAZARDS

ETERMINE THE LOCATION FOR THE OUTLET PIPE.

ETERMINE THE LOCATION FOR THE INLET PIPE.

SOURCE & DRAIN WATER SADDLE VALVE

SHUT OFF THE WATER

LOCATE THE WATER SHUT-OFF VALVE FOR THE COLD WATER FEED LINE OF YOUR MAINS SUPPLY.

ACCIDENTALLY HOOKING UP THE SYSTEM TO THE HOT SUPPLY LINE WILL PERMANENTLY DAMAGE THE

MEMBRANE

(SEE CONDITIONS FOR OPERATION). TO ASSURE YOU ARE USING THE COLD WATER LINE,

TURN ON BOTH THE HOT AND COLD TAP

. AFTER THE WATER IS WARM TO THE TOUCH, FEEL THE PIPES

UNDER THE SINK

. IT WILL BE EASY TO IDENTIFY THE HOT AND COLD PIPES.

LOSE THE COLD WATER VALVE. TURN ON THE COLD WATER TAP ONLY TO ASSURE THAT THE LINE IS

COMPLETELY SHUT OFF AND THE LINE IS DRAINED

… IF NO SHUT OFF VALVE IS LOCATED UNDER THE SINK,

TURN OFF THE MAIN SUPPLY AT THE ENTRY TO THE HOUSE

INSTALLING THE DRAIN CLAMP

ELECT A LOCATION FOR THE DRAIN HOLE BASED ON THE DESIGN OF THE PLUMBING. POSITION THE

DRAIN OUTLET SADDLE ON THE DRAINPIPE

. ALLOW ADEQUATE SPACE FOR DRILLING. TIGHTEN THE BOLTS

EVENLY ON BOTH SIDES

. AVOID OVER TIGHTENING.

USING THE OPENING IN THE DRAIN OUTLET SADDLE AS A GUIDE, DRILL A ¼” HOLE IN THE DRAIN PIPE.

CLEAN

DEBRIS FROM THE SADDLE AND THREADS

INSTALLING SUPPLY FEED