Installation guide

RO-MAN REVERSE OSMOSIS SYSTEM INSTALLATION GUIDE

PLEASE READ THIS ENTIRE GUIDE

PRIOR TO BEGINNING INSTALLATION.

HIS WATER SYSTEM HAS BEEN DESIGNED FOR QUICK AND SIMPLE INSTALLATION AND MAINTENANCE. BY

CAREFULLY READING THIS INSTRUCTION MANUAL AND FOLLOWING THE OPERATIONAL GUIDELINES YOU

WILL INSURE A SUCCESSFUL INSTALLATION AND RELIABLE OPERATION

. ROUTINE MAINTENANCE IS

ESSENTIAL TO THE LONGEVITY AND PERFORMANCE OF THE SYSTEM

. FILTERS SHOULD BE CHANGED

EVERY TWO TO SIX MONTHS DEPENDING ON THE QUALITY OF THE FEED WATER SUPPLY AND THE QUANTITY

OF WATER PRODUCED

CAUTION

DO NOT USE THIS SYSTEM WHERE THE WATER IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY.

CONDITIONS FOR OPERATION

TFC – Thin Film Composite

Source Water Supply – TEC

COMMUNITY/PRIVATE NON-CHLORINATED – OR CHLORINATED AS LONG AS THE

CARBON FILTER IS IN PLACE AND REPLACED EVERY

6 MONTHS

OR AFTER

RECOMMENDED GALLON THROUGHPUT,

WHICHEVER COMES FIRST

EMBRANES ARE DAMAGED BY CHLORINE.

SYSTEM PRESSURE (PRE-FILTRATION) 0-75 PSI

MEMBRANE PRESSURE RANGE 40-125 PSI

TEMPERATURE 4º-38º C (40º-100º F)

PH RANGE 3.0-13.0

MAXIMUM SUPPLY TDS LEVEL 1500 MG/L

TURBIDITY <1.0 NET TURBIDITY (NTU)

CHEMICAL PARAMETERS – TEC

HARDNESS (CACO.) <350 MG/L (<20 GPG)

IRON (FE) <0.1 MG/L

MANGANESE (MN) <0.05 MG/L

HYDROGEN SULFIDE (H2S) 0.00 MG/L

CHLORINE (CL2) 0.00 MG/L

RO-MAN.COM LTD Page 2 of 15