USER MANUAL 150W, 300W, 600W, 1500W Pure Sine Wave Power Inverter
Greeting from RND Dear Customer, Thank you for your preferred choice in purchasing our RND inverters. Our power when traveling, outdoors camping, at sea, etc. Low DC current is converted into series can be used to operate most TVs, VCRs, sound systems, PCs & laptops, whenever and wherever you are. You will have to install and use your RND inverters properly according to our Sincerely yours, RND.
General safety, installation, & operating guidelines GENERAL SAFETY • • • 3Failure to properly connect wiring between inverter and power source will result in reverse polarity. Reverse polarity will blow the internal fuse in the inverter and permanently damage said inverter. Damage caused by reverse polarity is not covered under RND warranty. • • • capacitors within the inverter. • shock.
• abnormally warm. • 30 to 60 minutes and let it run for approximately 10 minutes to recharge the • • Always disconnect the inverter when not in use. • Do not expose the inverter to moisture. • Avoid placing inverter near sources of heat or under direct sunlight. • General safety, installation, & operating guidelines equipment or appliance.
Some refrigerators, freezers, pumps and other similar equipment and appliances made and that the power source is fully charged. Then, follow step by step range. Turn inverter switch OFF, ON, OFF, and ON again in quick succession. If unsuccessful, it is likely that the inverter model does not have the required start up INSTALLATION 2. Cables. Make sure to use the correct cables. A chart is provided below, for your reference: 150W 15A 2.5mm² 300W 30A 6.0mm² 600W 60A 12.0 or 16.
General safety, installation, & operating guidelines OPERATIONAL GUIDELINES Step 1 Remove inverter from its packaging. Check to verify Step 2 Connect the cables to the Power Input Terminals screws excessively. 12V / 24V power source. 12V / 24V power source. the LED indicators. LED indicators should be lighted.
Step 7 Plus the equipment/ appliance into the AC receptacle at the front panel of the inverter. Leave the equipment/ appliance switched OFF. Step 8 Set the power switches of both inverter and inverter is now ready to transfer power to the equipment/ appliance.
150W Pure Sine Wave Inverter …………………….………150W Maximum Surge Capability (Peak Power)…………..……..300W No Load Current Draw * 12V DC-115VAC ………………………..……< 0.5A * 24V DC-115VAC………………………..…….< 0.3A * 12V DC-230VAC ………………………..……< 0.6A * 24V DC-230VAC………………………..…….< 0.4A DC Input Voltage Range * 12V DC………..……………………………10.5V– 16.5V * 24V DC………………………………….…..…21V – 33V AC Output Voltage Range………………………..….115V/230V +/- 3% ………………………………………………………..> 85% * 12V DC………………………… .…….….…..10.5V * 24V DC…………………………………….…..21.
*Green : Power On *Orange : Over Temperature, Over Voltage & Low Voltage *Over temperature *Overload *Short circuit 300W Pure Sine Wave Inverter …………………..…………300W Maximum Surge Capability (Peak Power)……….….…..….500W No Load Current Draw * 12V DC-115VAC……………………………..< 0.5A * 24V DC-115VAC……………………………..< 0.4A * 12V DC-230VAC……………………………..< 0.7A * 24V DC-230VAC……………………………..< 0.5A DC Input Voltage Range * 12V DC………..……………………………10.5V– 16.5V * 24V DC………………………………….…..…21V – 33V AC Output Voltage Range………………………..….
* 12V DC…………………………….………….10.5V * 24V DC………………………………………...21.0V * 12V DC…………………………….………….10V * 24V DC………………………………………..20V Wave Form…………………………………..………………Sine Wave Dimensions (L x W x H)……………………………210 x 147 x 66 mm Net Weight……………………………………………………….1.
Maximum Surge Capability (Peak Power)………………...1000W No Load Current Draw * 12V DC-115VAC………………………….……<0.6A * 24V DC-115VAC…………………………….…<0.45A * 12V DC-230VAC……………………………….<1A * 24V DC-230VAC…………………………….…<0.6A DC Input Voltage Range * 12VDC……………………………………….10.7V–16.5V * 24VDC..……………………………………..21.4V – 33V AC Output Voltage Range ……………………………115V/230V +/- 3% ………………………………………………………...> 85% * 12V DC………………………………………….10V * 24V DC………………………………………….
1500W Pure Sine Wave Inverter 10 Minutes Power..…………………..……………………..…1800W Maximum Surge Capability (Peak Power)……………..…..3000W No Load Current Draw * 12VDC-115VAC……………………………….<1A * 24VDC-115VAC……………………………….<0.6A * 12VDC-230VAC……………………………….<1.6A * 24VDC-230VAC……………………………….<1A DC Input Voltage Range * 12VDC………………………………………10.7V– 16.5V * 24VDC………………………………………21.4V – 33V AC Output Voltage Range…………………………….115/230V+/ -3% ……………………………………………………….
*Over temperature *Overload *Short circuit Output Power DC input AC Ouput 150W 12V 230V 300W 12V 230V RND 320-00009 24V 230V 600W 12V 230V RND 320-00010 RND 320-00013 24V 230V 1500W 12V 230V RND 320-00011 24V 230V RND 320-00008 RND 320-00012 RND 320-00014 All 230V models are CE and E-mark Compliance. Should you have maintenance of this inverter unit, please get in touch with our customer service.
Distrelec Group AG Grabenstrasse 6, CH-8606 Nänikon
