User Manual

RND 315-00007, 315-00008, 315-00014 — AC-DC DIN RAIL MOUNTED POWER SUPPLY
12 13
PRODUCT SPECIFICATION
25mm
or m ore
25mm
AIR
AIR
25mm
L
N
L
N
Mounting method should be considered with airflow. Leave enough space between the units
when several units are mounted together. Forced air cooling makes protection against heat
better.
Application Note
(3) Mounting Spacing
3. Mounting Method
din rail power supply
www.pairuigroup.com
Page:15/17
PAIRUI ELECTRONICS
Updated 2016-V1.0-1206
PRODUCT SPECIFICATION
(1) Please confirm if the capacity of the product is suitable for your intended application be-
fore putting it in use;
(2) Only the rated input voltage specified on the product should be used;
(3) Only the wires with rated capacity should be connected to this product, as allowable vol-
tage and current is varied according to each type of wire;
(4) Ground terminal of the power supply must be grounded before use to prevent electric sh-
ock or electromaganetic interference;
(5) Be cautions to keep the product clean as foreign matter near the input & output terminal
or inside if the product could c
ause series damages;
(6) If a fuse installed in the product blows off, the product should experience damages not
only to the fuse but also to other parts as well. Therefore, the product is to be required for
maintenance work from customer service department as well as replacement of the fuse;
(7) Due to constant leakage current flows within the product, extra caution should be made
if multiple number of products are used connecting to each other as total leakage current c-
ould be amounted beyond the capacity;
(8) Be sure to avoid any physical contact with the product since some of the parts in
side of
the product are being functioned at high voltage, which could cause serious electric shock;
(9) For the purpose of safety as well as reliability of the product, please avoid using the pro-
duct at the following sites:
- A place near water or fire
- A place with high room temperature and poor ventilation
- A place with a presence of foreign subject or dust
- A place near volatile or flammable compounds
- A place with high humidity
- A place vulnerable for vibration or shock
(10) Do not inspect or repair the product while the power is applied;
(11) Unauthorized modification sho
uld be avoided in order to prevent series injury or physic-
al loss due to any malfunction;
(12) In case of power outage while in operation, be sure to turn off the power supply.
Application Note
4. Cautions
din rail power supply
www.pairuigroup.com
Page:16/17
PAIRUI ELECTRONICS
Updated 2016-V1.0-1206
Updated 2016-V1.0-1206
www.pairuigroup.com
Page:17/17
PAIRUI ELECTRONICS
PRODUCT SPECIFICATION
(1) Repair service will be provided for free upon any mechanical, technical or functional de-
fects during the guaranteed warranty, however, any defects or malfunction due to internati-
onal infliction or negligence by customers will be repaired at the customer’s expense;
(2) Guaranteed warranty of the product runs for 3 years, while appearance and specification
of the product is subject for change without any prior notification for the purpose of quality
improvement of the product.
Application Note
5. Warranty
din rail power supply