User Manual

RND 315-00007, 315-00008, 315-00014 — AC-DC DIN RAIL MOUNTED POWER SUPPLY
10 11
PRODUCT SPECIFICATION
(1) How to fix
Firstly hang A part on the top of Rail as shown in below, then push the power supply into B di-
rection to fix it.
Remove the power supply to D direction, pulling C part by using tools, such as a screwdriver,
to downward direction.
Application Note
3. Mounting Method
(2) How to remove
din rail power supply
www.pairuigroup.com
Page:14/17
PAIRUI ELECTRONICS
Updated 2016-V1.0-1206
PRODUCT SPECIFICATION
Note:
1. Parallel operation should be composed with the same products, while the connection sho-
uld be as shown as “Parallel operation C”;
2. In parallel operation C, current capacity cannot be increased, while it should be used for
backup only. Moreover, diode that is to be added during parallel operation should be selected
after considering it’s voltage drop, output voltage and current capacity.
L
N
L
N
LOAD
LOAD
L
N
L
N
L
N
L
N
LOAD
Parallel Operation A
(Unable to use)
Parallel Operation B
(Unable to use)
Parallel Operation C
(Backup)
Application Note
2. Parallel Operation
din rail power supply
www.pairuigroup.com
Page:13/17
PAIRUI ELECTRONICS
Updated 2016-V1.0-1206