Datasheet

Rechargeable Battery AA / HR6
4.1 Performance：
Test Unit Specification Condition Remarks
Open Circuit Voltage
(OCV)
V
≥1.25
Within 1hr after standard
charge
Unit cell
4.2 Service Performance:
Test Unit Specification Condition Remarks
Standard Discharge
(0.2C
5
)
minute
≥300
Standard Charge , 1hr rest
before discharge
Up to 3 cycles are
allowed.The test
shall be terminated at the
end of the first cycle
which meets the
requirment
High Rate Discharge (1C
5
)
minute
≥48
Standard Charge , 1hr rest
before discharge
Charge Retention mAh
≥1600
(80%C
5
)
Standard charge
Storage 12 months at 20℃
Standard discharge
IEC Cycles Test Cycle
≥500
IEC 61951-2 (see note 3)
5. Security Characteristics:
5.1 Short-circuit explosion-proof characteristics
Samples: 10pcs
Test conditions: After standard charge. short circuit the cell at 20+/-2℃ until the cell temperature returns to ambient
temperature.(The resistance of the inter-connecting circuitry shall not exceed 0.1 ohm.)
Requirement: No fire and No explosion; Leakage/deformation is allowable.
Criterion: 0/10
6. Caution:
1. Batteries should be charged prior to use
2. For charging methods please referred to our technical handbook
3. Use the correct charger for Ni-Cd or Ni-MH batteries
4. Do not reverse charge batteries
5. Do not subject batteries to adverse condition such as extreme temperature, deep cycling and excessive over charge/over discharge.
6. Avoid batteries being used in an airtight compartment. Ventilation should be provided inside the battery compartment, otherwise
batteries may generate hydrogen gas, which could cause an explosion if exposed to an ignition source
7. Do not attempt to take batteries apart or subject them to pressure or impact. Heat may be generated or fire may result. The alkaline
electrolyte is harmful to eyes and skin, and it may damage clothing upon contact.
8. Keep away from children. If swallowed, contact a physician at once.
9. Do not short circuit batteries, permanent damage to batteries may result
10. Do not incinerate or mutilates batteries, may burst or release toxic material.
11. Do not solder directly to cells or batteries.
12. Store batteries in a cool dry place.
13. If find any noise, excessive temperature or leakage from a battery, please stop its use.
14. When using a new battery for the first time or after long term storage, please fully charge the battery before use
15. When using a new battery in use with semi-used batteries, over-discharge may occur.
16. Do not mix new batteries in use with semi-used batteries, over-discharge may occur.
17. When connecting a battery pack to a charger, ensure correct polarity.
18. When the battery is hot, please do not touch it and handle it, until it has cooled down.
19. Do not remove the outer sleeve from a battery pack nor cut into its housing.
20. When find battery power down during use, please switch off the device to avoid over discharge.
21. Unplug a battery by holding the connector itself and not by pulling at its cord.
22. After use, if the battery is hot, before recharging it, cool it in a well-ventilated place out of direct sunlight.
23. Never put a battery into water or seawater
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com