Datasheet

Revision date: 19/02/2020 Revision: 2

Distrelec Acrylic Conformal Coating - 400ml aerosol

Specific end use(s) The identified uses for this product are detailed in Section 1.2.

SECTION 8: Exposure controls/Personal protection

8.1. Control parameters

Occupational exposure limits

Petroleum gases, liquefied

Long-term exposure limit (8-hour TWA): WEL 1000 ppm 1750 mg/m³

Short-term exposure limit (15-minute): WEL 1250 ppm 2180 mg/m³

Toluene

Long-term exposure limit (8-hour TWA): WEL 50 ppm 191 mg/m³

Short-term exposure limit (15-minute): WEL 100 ppm 384 mg/m³

butanone

Long-term exposure limit (8-hour TWA): WEL 200 ppm 600 mg/m³

Short-term exposure limit (15-minute): WEL 300 ppm 899 mg/m³

WEL = Workplace Exposure Limit.

Sk = Can be absorbed through the skin.

8.2. Exposure controls

Protective equipment

Appropriate engineering

controls

Provide adequate ventilation. Personal, workplace environment or biological monitoring may

be required to determine the effectiveness of the ventilation or other control measures and/or

the necessity to use respiratory protective equipment. Use process enclosures, local exhaust

ventilation or other engineering controls as the primary means to minimise worker exposure.

Personal protective equipment should only be used if worker exposure cannot be controlled

adequately by the engineering control measures. Ensure control measures are regularly

inspected and maintained. Ensure operatives are trained to minimise exposure.

Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates

eye contact is possible. Personal protective equipment for eye and face protection should

comply with European Standard EN166. Wear tight-fitting, chemical splash goggles or face

shield. If inhalation hazards exist, a full-face respirator may be required instead.

Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn if

a risk assessment indicates skin contact is possible. The most suitable glove should be

chosen in consultation with the glove supplier/manufacturer, who can provide information

about the breakthrough time of the glove material. To protect hands from chemicals, gloves

should comply with European Standard EN374. Considering the data specified by the glove

manufacturer, check during use that the gloves are retaining their protective properties and

change them as soon as any deterioration is detected. Frequent changes are recommended.

Other skin and body

protection

Appropriate footwear and additional protective clothing complying with an approved standard

should be worn if a risk assessment indicates skin contamination is possible.