Datasheet

Revision date: 13/02/2019 Revision: 1.1
Distrelec Invertible Duster 420ml
Advice on general
occupational hygiene
Wash promptly if skin becomes contaminated. Take off contaminated clothing. Wash
contaminated clothing before reuse. Do not eat, drink or smoke when using this product.
Wash at the end of each work shift and before eating, smoking and using the toilet. Change
work clothing daily before leaving workplace.
7.2. Conditions for safe storage, including any incompatibilities
Storage precautions Store in accordance with local regulations. Keep only in the original container. Keep container
tightly closed, in a cool, well ventilated place. Keep containers upright. Protect containers from
damage. Protect from sunlight. Do not store near heat sources or expose to high
temperatures. Do not expose to temperatures exceeding 50°C/122°F. Bund storage facilities
to prevent soil and water pollution in the event of spillage. The storage area floor should be
leak-tight, jointless and not absorbent.
Storage class Chemical storage.
7.3. Specific end use(s)
Specific end use(s) The identified uses for this product are detailed in Section 1.2.
SECTION 8: Exposure controls/Personal protection
8.1. Control parameters
Occupational exposure limits
Carbon Dioxide
Long-term exposure limit (8-hour TWA): WEL 5000 ppm 9150 mg/m³
Short-term exposure limit (15-minute): WEL 15000 ppm 27400 mg/m³
WEL = Workplace Exposure Limit
8.2. Exposure controls
Protective equipment
Appropriate engineering
controls
Provide adequate ventilation. Personal, workplace environment or biological monitoring may
be required to determine the effectiveness of the ventilation or other control measures and/or
the necessity to use respiratory protective equipment. Use process enclosures, local exhaust
ventilation or other engineering controls as the primary means to minimise worker exposure.
Personal protective equipment should only be used if worker exposure cannot be controlled
adequately by the engineering control measures. Ensure control measures are regularly
inspected and maintained. Ensure operatives are trained to minimise exposure.
Eye/face protection Eyewear complying with an approved standard should be worn if a risk assessment indicates
eye contact is possible. Personal protective equipment for eye and face protection should
comply with European Standard EN166. Unless the assessment indicates a higher degree of
protection is required, the following protection should be worn: Tight-fitting safety glasses.
Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn if
a risk assessment indicates skin contact is possible. The most suitable glove should be
chosen in consultation with the glove supplier/manufacturer, who can provide information
about the breakthrough time of the glove material. To protect hands from chemicals, gloves
should comply with European Standard EN374. Considering the data specified by the glove
manufacturer, check during use that the gloves are retaining their protective properties and
change them as soon as any deterioration is detected. Frequent changes are recommended.
Other skin and body
protection
Appropriate footwear and additional protective clothing complying with an approved standard
should be worn if a risk assessment indicates skin contamination is possible.
4/
12