Datasheet

ESD Bench Mat 2 Layer
– Smooth Finish
Test Method Unit Value
Surface Resistance ANSI/ESD S4.1 Ω 1x10
6
≤ R ≤ 1 ≥ 10
9
Bottom Resistance ANSI/ESD S4.1. Ω 1x10
3
≤ R ≤ 1 ≥ 10
6
Thickness mm Permissible tolerance +0.1
Temperature Resistance
o
C 180 (instantaneous temp)
Test Results
Grounding
Sufficient ground cords should be used to reliably meet EN 61340-5-1 Table 3 less than 1 x 10
9
ohms for working surfaces.
Industry recommendation is that continuous runs of ESD matting should be grounded at 10ft intervals to allow proper charge decay
rates. Each individual ESD mat should be grounded with ground snaps located no further than five feet from either end.
Cleaning
Please note that contact between the matting surface and any acid or alkali solvent is strictly prohibited (such as Benzene,
Alcohol etc), this will result in the antistatic performance wearing away. If cleaning is required, the matting may be wiped with a cloth
coated in a neutral solution (such as water).
Guidance on use
Matting materials have a tendency to shrink slightly when first unrolled. In applications where length is critical, allow the
material to relax for at least 4 hours before cutting to size. Matting should always be trimmed with a sharp knife or razor blade.
Cutting tolerances
Width + 6mm
Length + 6mm every linear foot of running material
RoHS Compliance
All of Antistat’s products are RoHS and Reach compliant.
Product Code Description Size (mm) Additional Notes
RND 600-00057 *
ESD Bench Matting - Smooth Finish 600 x 1200 Blue (Each)
RND 600-00058 *
ESD Bench Matting - Smooth Finish 600 x 1200 Grey (Each)
RND 600-00059 *
ESD Bench Matting - Smooth Finish 600 x 900 Grey (Each)
* These pre-cut mats are supplied with studs
Pre cut mats are supplied with grounding studs added in each corner as standard, as specified in Fig 1.
Stud Size: 10mm.
RND is a trademark of Distrelec