User Manual
EN
4
To start the soldering iron heang, just li the soldering iron from the rack to start the machine and start
heang.
3. Set Celsius °C or Fahrenheit °F to display the temperature:
Press SET and then press to convert to °C or °F to display the temperature.
Working Temperature
If you are manufacturing to RoHS requirements, the 60/40 solder alloys are not allowed in the producon
process. For lead free solder alloys, a working temperature of 30° higher than leaded electrical soldering is
required. The working temperature of lead-free solder is detailed below, but can vary from manufacturer to
manufacturer.
• Melng point 227°
• Normal operaon 300-360°
• Producon line operaon 360-410°
When the iron’s working temperature is set within the parameters suitable for the type of solder being used,
a good joint is assured. Too low a temperature will slow the rate of solder ow while a high temperature
seng might burn the ux in the solder and emit a heavy white smoke resulng in a dry joint or permanent
damage to the printed circuit board (P.C.B). This may also shorten the p life.
IMPORTANT: The temperature above 410°C is not recommended for normal soldering funcons, but can be
used for short periods of me when high temperatures are required. Please note that the lead free solder
alloys require a higher soldering temperature which shortens p life.
Operang Instrucons
Ensure that the mains input voltage is between 220-240V before beginning use. Check carefully for any
damage during transportaon.
This unit contains:
1. Solder handle.
2. Iron holder with brass p cleaner.
3. AC power cord with plug.
CAUTION: REMEMBER, THE TIP IS HOT. The p and barrel of the solder handle will cause serious burns if
they are allowed to contact the skin. Always return the solder handle to the safety holder aer each use.
Soldering irons operate at high temperatures and can easily burn people or objects. Do not touch the p
and heater at any me and keep it a safe distance from ammable materials while the unit is on or while it’s
cooling. Please allow a sucient me for the unit to cool before changing ps or handles!
DO NOT WORK ON LIVE CIRCUITS. Before working on any mains powered equipment, make sure that it is
turned o, and the mains plug is removed from the power point.
DO NOT USE IF DAMAGED. If the power lead becomes damaged or the soldering staon becomes faulty,
disconnue use immediately.