Datasheet

Desoldering Flux Coated Braid
MATERIAL SAFETY DATA SHEET
Date of issue: 5/11/2017
RND is a trademark of
Distrelec
Conforms to
Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission
Regulation (EU) 2015/830
SECTION 7: Handling and storage
The information in this section contains generic advice and guidance. The list of Identified Uses in Section 1 should be consulted
for any available use-specific information provided in the Exposure Scenario(s).
7.1 Precautions for safe handling
Protective measures :
Advice on general
occupational hygiene
:
7.2 Conditions for safe storage, including any incompatibilities
Put on appropriate personal protective equipment (see Section 8). Do not ingest. Avoid
contact with eyes, skin and clothing. Avoid release to the environment. Keep in the original
container or an approved alternative made from a compatible material, kept tightly closed
when not in use. Empty containers retain product residue and can be hazardous. Do not
reuse container.
Eating, drinking and smoking should be prohibited in areas where this material is handled,
stored and processed. Workers should wash hands and face before eating, drinking and
smoking. Remove contaminated clothing and protective equipment before entering eating
areas. See also Section 8 for additional information on hygiene measures.
Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and well-
ventilated area, away from incompatible materials (see Section 10) and food and drink. Keep container tightly closed and
sealed until ready for use. Containers that have been opened must be carefully resealed and kept upright to prevent leakage.
Do not store in unlabelled containers. Use appropriate containment to avoid environmental contamination.
Seveso Directive - Reporting thresholds (in tonnes)
Danger criteria
Category
E1: Hazardous to the aquatic environment - Acute 1 or
Chronic 1
100 200
Notification and MAPP
threshold
Safety report threshold
7.3 Specific end use(s)
:
:
Recommendations
Industrial sector specific
solutions
Not available.
Not available.
Recommended monitoring
procedures
If this product contains ingredients with exposure limits, personal, workplace atmosphere or
biological monitoring may be required to determine the effectiveness of the ventilation or
other control measures and/or the necessity to use respiratory protective equipment.
Reference should be made to monitoring standards, such as the following: European
Standard EN 689 (Workplace atmospheres - Guidance for the assessment of exposure by
inhalation to chemical agents for comparison with limit values and measurement strategy)
European Standard EN 14042 (Workplace atmospheres - Guide for the application and use
of procedures for the assessment of exposure to chemical and biological agents) European
Standard EN 482
(Workplace atmospheres - General requirements for the performance of procedures for the
measurement of chemical agents) Reference to national guidance documents for methods
for the determination of hazardous substances will also be required.
:
SECTION 8: Exposure controls/personal protection
The information in this section contains generic advice and guidance. Information is provided based on typical anticipated
uses of the product. Additional measures might be required for bulk handling or other uses that could significantly
increase worker exposure or environmental releases.
8.1 Control parameters
Occupational exposure limits
No exposure limit value known.