Datasheet

SAFETY DATA SHEET
SOLDERING TIP CLEANER
According to Regulation (EU) 2015/830, amending Annex II of Regulation
(EC) N
o
1907/2006 (REACH)
Revision date: 09/11/2016
Page 5/10
8.2. Exposure controls
Appropriate engineering control
Do not breathe gas/fumes/vapour/spray.
Protective and hygiene measures
Remove contaminated, saturated clothing immediately. Protect skin by using skin protective cream. After work, wash hands and
face. When using do not eat or drink.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
9.1. Information on basic physical and chemical properties
o
Physical state: Solid
Colour: Yellow
Odour: characteristic
Eye/face protection
For the protection against direct skin contact, body protective clothing is essential (in addition to the usual working clothes).
Hand protection
Addtional protection measures for the hands: Hand protection: DIN EN 374 -CR (polychloroprenes, Chloroprene rubber).
Thickness of glove material: : 0,65mm penetration time (maximum wearing period): : >120min. -NBR (Nitrile rubber).:
Thickness of glove material: : 0,4mm penetration time (maximum wearing period): : >480min. Revision No: 4,01 GB - E
Breakthrough times and swelling properties of the material must be taken into consideration. Take recovery periods for skin
regeneration . In the case of wanting to use the gloves again, clean them before taking off and air them well . Use gloves only
once. When handling with chemical substances, protective gloves must be worn with the CE-label including the four control
digits. Before using check leak tightness / impermeability.
Skin protection
For the protection against direct skin contact, body protective clothing is essential (in addition to the usual working clothes).
Respiratory protection
[In case of inadequate ventilation] wear respiratory protection. Use appropriate respiratory protection. Use only respiratory
protection equipment with CE-symbol including four digit test number. The filter class must be suitable for the maximum
contaminant concentration (gas/vapour/aerosol/particulates) that may arise when handling the product. If the concentration
is exceeded, closed-circuit breathing apparatus must be used! Filtering device (full mask or mouthpiece) with filter::A
Environmental exposure controls
No special measures are necessary