User Manual

6
Program seings:
CH1 to CH3 three program seings
Set as follows:
At the same time, hold down the SET buon on the screen and the green buon on the
handle for two seconds. Aer the indicator is released, the blue number 00 will start
ashing.
This gure is used to calibrate the temperature. Without adjustment, CH1 and the
temperature will start to ash when you press the SET buon. You can use the and
symbols below the CH to adjust the desired temperature. The adjustable temperature is
100°C-500°C.
Press the SET key again when adjusting to the desired temperature. The digits will start
to ash and the air volume can be adjusted from 0-200.
Press the SET key again to adjust the temperature of CH2. Then press SET to adjust the
ow of CH2. Press SET to adjust the temperature of CH3. Press SET again to adjust the
ow of CH3. Press SET again to adjust the conversion between °C and °F. Aer all the
programs have been adjusted, press ENTER again to complete all program seings.
Note: The air force is not adjustable to zero, the higher the temperature, the air volume
should remain high. To protect the life of the heating core.
Energy safe Function
Long press the green buon for three seconds, the host enters the dormant state. At
this time, the air volume is fully on, the temperature of the heater core is quickly cooled
to below 100°C, the display screen shows the moon as below :-
The fan stops running, and it enters the dormant state. To restart, remove press again.
Press the buon to start the host.
If the air gun is placed on the shelf, the hibernation function will also be activated. Pick up
the air gun host from the rack and start it instantly.
Displays the ––– symbol while sleeping
7
Nozzles replacement
Use a U-shaped piece on the front of the rack to remove the desoldering head, but use a
needle nose pliers when installing a new desoldering head
Factory seing:
CH1. Temperature 150°C Air volume 100, CH2. Temperature 300°C Air volume 120, CH3.
Temperature 450°C Air volume 180
Front Panel
No.
1
2
3
4
FUNCTION
Heating
Cooling
Standby
Set Temperature
DESCRIPTION
When lit, it shows that the element is heating up,
temperature increase. When it ashes, it shows
that the temperature is being maintained at the
set temperature.
When it appears on screen, it shows that they
element is cooling down, decreasing
temperature.
When it appears on screen it shows that they
element is in standby mode, and the heat gun is at
or near room temperature. Press White
buon – temperature will rapidly increase to
resume soldering.
Use the arrow buons to set the temperature to
a desired level, which is displayed here. CH0 is the
default operating mode, 100 – 500 °C