User Manual

Instructions:
1. Access to the power supply
①Plug it in.
②Push the switch to “hot air” after the surroundings are confirmed safe.
2. Operation
①The work can begin when the hot air is blowing out.
②Keep the item to be heated at a proper distance and blow the hot air to the item evenly.
3. After operation
①Push the switch to “air supply” and ensure the tool runs for more than three minutes so that its temperature drops down.
②After the temperature has dropped, push the switch to "off".
③Unplug the tool.
4. Storage after use.
Keep the tool in a dry place.
Continuous operating limit:
 Don't run the tool continuously for more than two hours.
 After using the tool, switch to "air supply" and keep it for more than three minutes. Then switch to "off" and let the tool rest
for more than 30 minutes.
 The life of its engine and heater is approximately 300 hours.
 If the engine makes abnormal sounds during use or the tool can't operate, stop the use immediately and turn to the vendor
or the customer consultation center.
Main usage:
 Processing of heat-shrink tubing.
When processing the heat-shrink tubing, ensure the tool is 10~60MM away.(Adjust the heating time and distance
according to different tube materials and thickness)
 Label removal.
Keep heating the label with hot air and remove the label slowly from its corner .
 Shrinkage of heat-shrink bags.
Put the item (such as a CD case, etc.) into a heat-shrink bag. Then seal the bag and blow the hot air following the direction
of the arrows to shrink it.
 For processing plastics, bamboo, etc.
Low Temperature Mini
Hot Air Gun
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com