Datasheet

Art. Nr.
RND 550-00175
SPECIFICATION:
Stripped values A 10 mm
Stripped values B 12 mm
Colour black
Length 108 mm
Weight 74 g
Stripping tool
FEATURES:
Coaxial stripping tool with three adjustable cuers
Tool is preseted for RG58/59/62/6 cable types
Total stripping distance 10 or 12 mm
With streamlined design, no need replacing cassee and adjusng V-block
Use the built-in hex wrench to align the socket and adjust the blade
10 mm, 12 mm
Stripping length is set to 12 mm if you want to strip other lengths, you may adjust the blade's position.
Blade's depth are preset .usually no adjustment is needed but if you find the stripper doesn't strip your cable well, then you may
use the hex wrench, which is installed on the bottom of the tool to adjust the blades' depth.
Stripping cable:
1. The stripper is designed for stripping cables without any adjustment of
V-block.
2. Press the knurled portion on the upper jaw to open the stripper's jaws.
3. Insert the cable you want to strip through the V-block until the cable reaches the V-shaped cable guide. Then release the upper
jaw to close the jaws
4. Insert your index finger into the stripper's finger ring, turn the stripper clockwise 3-5 times. The cable's insulation is cut while you
turn the stripper
5. Open the jaws and remove the cable. Pull away the outer jacket and dielectric to expose the inner conductor
INSTRUCTIONS:
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com