User Manual
9
Measuring L/C/R
Measuring D/Q/θ/DCR
Discharge the DUT (Device Under Test) before connecng the test probes.
The gures on the following pages show how to make basic measurements.
The auto test mode is the default mode when the meter is turned on. When the
meter in auto test mode, it will automacally detect the DUT and show the suitable
result on the dis play.
The meter can measure D (dissipaon factor), Q (quality factor), θ (phase) and
DCR (DC resistance) on the DUT.
• Press the D/Q/θ/DCR buon to enter D/Q/θ/DCR test mode.
• In D/Q/θ/DCR test mode, press the D/Q/θ/DCR buon to select measuring funcon.
• In auto test mode, press the AUTO L/C/R buon to enter manual test mode.
• In manual test mode, press the AUTO L/C/R buon to select measuring funcon.
• To return the auto test mode, press and hold the AUTO L/C/R buon > 2 sec.