User Manual

8 9
EN EN
3-5.Using the Input Terminals
• All funcons except current use the V/OHMS and COM input terminals.
• The two current input termin for 500mA and 10A current measurement.
10A: Input for 0A to 10.00A current (20A overload for 30 seconds on, 10 minutes o).
μAmA: Input for 0A to 500mA current measurements.
COM: Return terminal for all measurements.
VΩCAP Hz Temp: Input for Voltage, Connuity, Resistance, Diode Test, Conductance,
Capacitance.
4.Measure Funcon
4-1.AC Voltage Measurement
WARNING: Risk of Electrocuon. The probe ps may not be long enough to contact the live
parts inside some 240V outlets for appliances because the contacts are recessed deep in the
outlets. As a result, the reading may show 0 volts when the outlet actually has voltage on it.
Make sure the probe ps are touching the metal contacts inside the outlet before assuming
that no voltage is present.
CAUTION: Do not measure AC voltages if a motor on the circuit is being switched ON or OFF.
Large voltage surges may occur that can damage the meter.
1. Set the funcon switch to the VAC Posion.
2. Insert the black test lead into the COM Input Jack and the red test lead into the Posive
Input Jacks.
3. Posion the black test probe p and red test probe p respecvely in the spots of the
circuit to be measured.
4. Read the AC voltage in the display.
OFF
CAP
mA
AUTO POWER OFF
10A
mA
A
10A
V
10A
800mA
FUSED
COM
CAT IV 600V
CAT III 1000V
True RMS Autoranging Digital Multimeter
30 sec MAX
every 15 min
IP67
WATERPROOF
V
V CAP
Hz %
Temp
µA
AC+DC
Hz
%
Temp
°C °F
LPF
mA
%
4~20
mV
Bluetooth
RANGE
HOLD
REL
F1
F2
F4
F3
5. 0000
Auto range
06:32
GRAPH
01 23 4 5V
MODE SAVE MAX
V
4-2.DC Voltage Measurement
CAUTION: Do not measure DC voltages if a motor on the circuit is being switched ON or
OFF. Largevoltage surges may occur that can damage the meter.
1. Set the funcon switch to the VDC AC+DC Posion.
2. Insert the black test lead into the COM Input Jack and the red test lead into the
Posive Input Jacks.
3. Posion the black test probe p and red test probe p respecvely in the spots of the
circuit to be measured.
4. Read the DC voltage in the display.
OFF
CAP
mA
AUTO POWER OFF
10A
mA
A
10A
V
10A
800mA
FUSED
COM
CAT IV 600V
CAT III 1000V
True RMS Autoranging Digital Multimeter
30 sec MAX
every 15 min
IP67
WATERPROOF
V
V CAP
Hz %
Temp
µA
AC+DC
Hz
%
Temp
°C °F
LPF
mA%
4~20
mV
Bluetooth
RANGE
HOLD
REL
F1
F2
F4
F3
5. 0000
Auto range
06:32
GRAPH
-5 5V
MODE SAVE MAX
V
-4 -3 -2 -1 01 23 4