User Manual
30 31
EN EN
7.Replacing the Baeries
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the baery cover.
WARNING: To avoid electric shock, do not operate the meter unl the baery cover is in
place and fastened securely.
Refer to Figure and replace the baeries as follows:
1. Turn the Meter o and remove the test leads from the terminals.
2. Remove the baery door assembly by using a standard blade screwdriver to turn
the baery door screw one-half turn counterclockwise.
3. Replace the baeries with 7.4 volt charge baeries Observe proper polarity.
4. Reinstall the baery door assembly and secure it by turning the screw one-half
turn clockwise.
8.Replacing the Fuses
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the meter cover.
WARNING: To avoid electric shock, do not operate your meter unl the fuse cover is in place
and fastened securely.
Referring to Figure, examine or replace the Meter’s fuses as follows:
1. Turn the Meter o and remove the test leads from the terminals.
2. Remove the baery door assembly by using a standard blade screwdriver to turn
the baery door screw one-half turn counterclockwise.
3. Remove the fuse by gently prying one end loose, then sliding the fuse out of its bracket.
4. Install only specied replacement fuses.
5. Reinstall the baery door assembly and secure it by turning the screw one-half
turn clockwise.
6. Remove the six screws securing the rear cover.
7. Gently remove the old fuse and install the new fuse into the holder.
8. Replace and secure the rear cover, baery and baery cover.