USER MANUAL Prior to use this product, please read this manual carefully to avoid any damage caused by error operation or improper use. Distrelec Group AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T +41 44 944 99 11, info@distrelec.com, distrelec.
Introduction Thank you for purchasing this product. Before use, please read carefully the instructions for use. This product is a kind of device used as a tool, which is suitable for the detection of pipelines, narrow spaces, installation of equipment or fixtures, vehicle maintenance, etc., providing real-time video viewing and output functions. Product Features • Real-time video playback and output; • Mini 8mm waterproof LED Lens with 770mm flexible tube (Ben section of tube is of 4.4mm diameter); • 2.
Structure Mini waterproof camera Power indicator ON/OFF key Screen brightness adjustment key LED light brightness adjustment key Zoom key Flip/mirroring key Color LED screen VIDEO output interface Installation and Use 1. Open the battery compartment rear cover, install 4 AA batteries and press the battery cover back (Figure 1); place two fingers simultaneously at the “OPEN” positions and slightly dig inwards.
2. Accessories Installation (1) First place the single hook or mirror into the hole on the lens as indicated by the arrow, and then push the attachment fixture to secure it (as shown below). (2) First, insert the magnet into the attachment fixture, with the pointed end into the hole on the lens as indicated by the arrow, and then tighten the placed attachment fixture to secure it (as shown below). Attachment fixture Magnet 3.
4. When the camera’s ambient light is inadequate, the LED light can be turned on to adjust the brightness. As the brightness is adjusted to the maximum point, press the brightness adjustment key again to restore. LED brightness adjustment key 5. Press the screen brightness adjustment key to manually adjust the screen brightness. As the brightness is adjusted to the maximum point, press the brightness adjustment key again to restore.
. The zoom key allows you to zoom in the image; press once to zoom in by 1.5 times, press again to zoom in by 2.0 times, and press once again to restore. Zoom in by 1.5 times Zoom key Zoom in by 2.0 times 7. Press the flip/mirroring key to achieve mirroring and 180° flip of the video image. Flip/mirroring key Attentions 1. Pay attention to protection of the camera lens, wich shall not be folded by force and shall not be broken off. 2. The camera Tube is waterproof while the receiver is not.
Technical Parameters Items Specs Camera Diameter 8mm Image Sensor 1/9”, CMOS 640*480 pixels Effective Pixel Horizontal View Angle 45±5° 770mm Tube Lenght IP67(excluding the joint part) IP Grade AA x 4 Power Supply Display Dimensions 4.3” TFT LCD inch X1.5, X2 Image Zoom Ratios NTSC and PAL Video Formats Power Consumption 1.
-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
