Datasheet

DIY Straight 4 mm Banana (male)
Plug
RND Part Nr. Colour
RND 350-00138
Red
RND 350-00137 Black
How to use, to attach a wire
I gather a solder iron (150 W maxi.), some (lead or lead-free) tin
solder wire, a stranded or solid wire with the specifications
below, and a tool to strip the wire. I strip the end of the wire on 7
mm typically (4 mm at least).
Strands.
Jacket(s).
Ø2.3 mm maxi.
2.50 mm² maxi.
(approximately AWG14).
Ø6.3 mm maxi..
7 mm typically (4 mm mini.).
If the plastic part is screwed on the metal part then I unscrew it
and separate them.
I slip the stripped end of the wire into the hole of the metal part
until it abuts as shown below.
With the solder iron and the tin solder wire I solder the wire to
the metal part (it complies with both lead-free tin and lead-tin).
I insert the metal part into the plastic part ; I push the metal until
it abuts against the plastic part.
I hold the metal part, I hold the plastic part, I rotate to screw until
the metal part abuts against the plastic part (2.3 N.m maxi.
torque).
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com