Datasheet

Set of 4 DIY Straight 4 mm
Banana (male) Plugs
RND Part Nr.
RND 350-00079
How to use, to attach a wire
I gather a 2.5 mm flat-bladed screwdriver, a stranded or solid wire
with the specifications below, and a tool to strip the wire. I strip
the end of the wire on 7 mm typically (4 mm at least).
Strands.
Jacket(s).
Ø2.1 mm maxi..
1.50 mm² maxi.
(approximately AWG16).
Ø5.1 mm maxi..
7 mm typically (4 mm mini.).
If the plastic part is screwed on the metal part then I unscrew it
and separate them.
With the screwdriver I unscrew the screw without removing it.
I slip the stripped end of the wire into the hole of the metal part
until it abuts as shown below.
With the screwdriver I screw and tighten (2.3.m maxi. torque) the
screw on the end of the wire.
I insert the metal part into the plastic part ; I push the metal until it
abuts against the plastic part.
I hold the metal part, I hold the plastic part, I rotate to screw until
the metal part abuts against the plastic part (2.3 N.m maxi. torque).
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com