Datasheet

RND P
art Nr.
C
olou
r
RND 350-00
039
Red
RND 350-00
040
Blue
RND 35
0-00041
Yello
w
RND
350
-00042
RND
350
-00038
Black
G
reen
RND is a trademark of Distrelec
4 mm B
anana (female) Jack (socket)
Gather open-end spanners SW9 mm and SW8 mm, a panel with the
specifications below, and a tool to drill the panel as below.
Ø8.0 (+0.1/-0) mm
Drill the panel as above with the tool.
If the nuts and the spacer are mounted on the socket then remove them.
Push the socket into the hole of the panel as shown below.
Take care of the direction of the spacer (picture above) and put it on the
rear side of the socket. Then put one of the two nuts on the rear side of
the socket too. Hold the front hexagonal insulator with the spanner SW9,
hold the nut with the spanner SW8, then screw and tighten it (2.3 N.m
maxi. torque). Now the socket is attached to the panel as shown below.
To connect the socket can solder (150 watt maxi. iron solder with lead-tin
or lead-free tin) a wire on its terminal so screw and tighten the other nut
first (2.3 N.m maxi. torque) (it is a lock nut). Or attach a wire terminated
by a usual ring lug (4 mm² - 6 mm² ring lug) ,put the ring lug (picture
above) then screw and tighten the other nut (2.3 N.m maxi. torque). Then
the socket is ready to use.
Panel.
Maxi. thickness : 2 mm
(to comply with a 1 mm-thick lug).
Pitch circle diameter to drill the panel :
Rear face of the panel. Front face of the panel.
Spacer. Nuts. Panel.
Ring lug (not provided).
How to implement