Datasheet

DIY Straight 4 mm Banana
(female) Jack
RND i
s a trademark of Distrelec
RND Part Nr. Colour
RND 350-00034
Red
RND 350-00036
Blue
RND 350-00037
Yellow
RND 350-00052
RND 350-00032 Black
Green
How to Use, Attach a Wire
Gather a 3.5 mm flat-bladed screwdriver, a solder iron (150 W
maxi.), some (lead or lead-free) tin solder wire, a stranded or
solid wire with the specifications below, and a tool to strip the
wire. Strip the end of the wire on 7 mm typically (6 mm at least).
If the plastic part is screwed on the metal part then unscrew it
and separate them.
Slip the stripped end of the wire into the hole of the metal
part until about 1 mm only of the stripped length is visible as
shown below.
With the solder iron and the tin solder wire solder the wire to
the metal part (it complies with both lead-free tin and lead-tin).
Insert the metal part into the plastic part. Hold the plastic part,
Insert the blade of the screwdriver into the slot of the metal part ;
screw until the metal part abuts against the plastic part
(2.3 N.m maxi. torque).
Strands.
Jacket(s).
Ø0.6 mm maxi.
0.30 mm² maxi.
(approximately AWG22).
Ø2.7 mm maxi..
7 mm typically (6 mm at least).
About 1 mm.