Datasheet
TONE GENERATOR
INSTRUCTIONS:
1. Connecting the Tone generator.
In terminated working cables:
Connect one test lead to a terminated wire and other test lead to earth or
equipment ground.
In unterminated or non-working cables:
Connect one test lead to a terminated wire and other test lead to earth or
equipment ground.
2. Depress the round on/o spring-loaded buon of the amplier probe. The
volume control switch can be adjusted to suit the environment. Volume can be
increased to overcome noise, or decreased to reduce interference.
3. Touch the tip of the amplier probe to the insulation of each suspect conductor.
4. Reception of tone will be loudest on the subject wire.
5. The plug receptacle is provided for connecting to a head set or hand set.
MAINTENANCE:
The Amplier Probe is maintenance free except for baery replacement.
Remove the screw from the baery compartment, replace the 9V baery
and reassemble.
Warranty limited solely to repair or replacement; no warranty of
merchantability, tness for a particular purpose or consequential damages.
FEATURES:
• Red or black test leads are provided, and has a standard 4 conductor modular
cord and plug.
• A 3-position toggle switch controls the modes of operation plus 3-colored LED
Light Emiing Diode is provided for line polarity, continuity and voltage testing.
• A tone selector switch, located inside the test set is provided for choosing either
a single solid tone or dual alterating tone.
(CAUTION: DO NOT CONNECT TO AN ACTIVE AC CIRCUIT EXCEEDING
24V IN THIS MODE.)
-2-