User Manual

ManualsBrandsRND Lab ManualsChemicalsCordes Automatic Water Tap, Silver

Instruction manual

IR Water Sensor

Dear customer,

Congratulations on the acquisition of one of our quality products. Please read the instruction manual carefully before use and keep it in a safe place.

Product description

This IR water sensor helps save a lot of water, and hence costs, in the household (up to 70%). As soon as hands are placed under the sensor, the water

starts running and is then turned off immediately after the sensor area is vacated. The taps remain more hygienic, e.g. because the water tap does not have to

be turned on first with dirty hands.

Contents

Flat mounting wrench

Rubber Seal

Screw cap

Top

Bottom

Button

Operation LED (green)

Change battery (red)

Battery compartment

Screw cap

Rubber Seal

Inserting the battery

Insert battery

(1) Pull out the battery

compartment

(2) Insert 4 AAA batteries

Only attempt with dry hands

(3) Slide the battery compartment back into

the device

Summary of content (4 pages)

PAGE 1
Instruction manual IR Water Sensor Dear customer, Congratulations on the acquisition of one of our quality products. Please read the instruction manual carefully before use and keep it in a safe place. Product description This IR water sensor helps save a lot of water, and hence costs, in the household (up to 70%). As soon as hands are placed under the sensor, the water starts running and is then turned off immediately after the sensor area is vacated. The taps remain more hygienic, e.g.
PAGE 2
Water tap with external thread Screw cap Top (3) First tighten with the flat mounting key Rubber Seal Thread Flat mounting wrench (1) Remove the existing water tap outlet valve (make sure that the rubber seal has also been removed) (4) Carefully tighten the screw cap (2) Install the device Water tap with internal thread Bottom Screw cap Rubber Seal Thread (1) Remove the existing water tap outlet valve (make sure that the rubber seal has also been removed) Flat mounting wrench (2) Install the dev
PAGE 3
Sensor setup Setting the sensor range a) Automatic adjustment (5-25cm) b) manual range adjustment Green light 1. Switch off the device 2. Press the RESET button until the green LED starts flashing (about 5 seconds) 3. Let go of the button. The green LED will stop flashing after 10 seconds 4. Switch on the device Green light 1. Switch off the device 2. Determine the distance with your hand 3. Press the RESET button with your other hand until the green LED starts flashing (about 5 seconds) 4.
PAGE 4
- We recommend the use of alkaline batteries for best performance. - Never mix old and new batteries or disposable and rechargeable batteries. - Never use different types of batteries (e.g. alkaline and zinc-carbon) at the same time. - Remove the batteries if you are not going to use the unit for a long time. Leaking batteries can permanently damage the unit. - Notes on battery disposal: Batteries are subject to legal regulations.