Datasheet

5-9. Rapid change of temperature. (Testing method IEC 68-2-14 Na)
The test capacitor shall be kept in the testing ove
n and kept at condition of following table, and it shall be repeated for 5 cycles
successively. After the test, the capacitor shall be let alone at the ordinary condition for 2 hours.
Step Temperature Minute
1
-40±3°C
30±3
2
Ordinary
3
105±
2°C
30 ± 3
4
Ordinary
Performance
Capacitance change: Δ C/C : ≤ ± 10%
DF change: Δtan δ : ≤ 0.1% at 1 KHZ
Insulation resistance: ≥ 50% of limit value
6.Mechanical characteristics
6-1.Terminal strength (Testing method IEC 68-2-21)
Tensile: (Test Ual)
A load of 10 N(1.0kg) shall be gradually applied to the terminal in the axial direction and held thus
for 10
sec.
Bending : (Test Ub)
While a load of 500g
applied to the lead wire, the body of the capacitor shall be bent 90º and returned to the original
position. Th
is operation shall be
conducted in a few seconds. Then the body shall be bent 90º at the same speed in the
opposite direction and returned to the original position.
Performance :
There shall be no such mechanical damage as t
erminal damage etc.
7.Endurance characteristics
7-1. Solderability (Testing method IEC 68-2-20 Ta)
Solder temperature: 235 °C±2 °C.
Immersi
on time: 2±0.5 sec.
For other procedures refer to JIS C 0050
Performance:
At least 95% of the circumferential face of lead wire up to immersed level shall be covered with new solder.
3 or under
3 or under
Distrelec Group AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com