Datasheet

Appearance
Shall be no mechanical damage
5.5 Vibration
Resistance
Connection strength
Appearance
Shall be no remarkable change.
The marking shall be legible.
Withstand Voltage
Between Terminals
Shall satisfy NO.3.1
Capacitance Change Rate Within ±3% of the value before test
5.6 Soldering
Heat
Resistance
Dissipation Factor
@ 1KHz: 0.002 (0.2%) max.
Insulation Resistance
≥50% of the limit value of NO.3.4
Preheat Temp. : 100~120 °C
Preheat Duration : 60 sec. max. Temperature
Increase by 3 °C/sec. max. Soldering
Temperature : +260 ± 5 °C Immersion
Duration : 5 ± 1sec.
Immersion Depth : 4 ± 0.8mm from roots.
After test, allow it stay alone for 1.5 ± 0.5 hrs.
at ordinary condition before making
measurements.
Connection of Element
Shall be stable
Frequency Change: 10-55-10 Hz
Vibration Distance: 1.5 mm
Test Direction XYZ
Test Duration 2+1/-0 hrs each direction
Shall be no short-circuiting or open.
The connection shall be stable.
5.7 Endurance
Appearance
Shall be no remarkable change
Test Voltage: 125% * rated voltage.
Test Duration: 1,000 Hrs.
Once every hour the voltage is increased to
1000 V rms. For 0.1 sec. The test voltage is
applied to each capacitor individually
through a resistor of 47Ω±5 %.
Withstand
Voltage
Shall satisfy NO.3.1
Capacitance Change Rate
Within±10% of the value before test
Dissipation Factor
1KHz Cr ≤1uF : 0.008 (0.8%)
max. Cr >1uF : 0.005 (0. 5%)
Insulation Resistance
≥50% of the limit value of NO.3.4
6.7 Moisture
Resistant
Loading
Appearance
Shall be no remarkable change
Withstand
Voltage
Shall satisfy NO.3.1
Capacitance Change Rate
Within ±5% of the value before test
Dissipation Factor
@ 1KHz: 0.002 (0.2%) max.
Insulation Resistance
≥50% of the limit value of NO.3.4
Test Temperature: +40 ± 2 °C.
Test
Humidity: 87% to 93%
R.H. Test Voltage: rated voltage.
Test Duration: 500 Hrs.
After test, allow it stay alone for 1.5 ± 0.5 hrs.
at ordinary condition before making
measurements.
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com