Datasheet

RGB SMD LED, 0606
Caution
1. Over-current-proof
Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out wil
l happen).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 80%RH or less. 2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 60%RH or less. 2.5 The LEDs should be used within 168 hours (7
days) after opening the package.
2.6 If the moisture adsorbent material has fabled away or the LEDs have exceeded the storage time, baking treatment should be
performed using the following conditions. Baking treatment: 60±5℃ for 24 hours.
3. Soldering Condition
When soldering, for Lamp without stopper type and must be leave a minimum of 3mm
clearance from the base of the lens to the soldering point.
To avoided the Epoxy climb up on lead frame and was impact to non-soldering problem, dipping the lens into the solder must be avoided.
Do not apply any external stress to the lead frame during soldering while the LED is at high temperature.
Recommended solde
ring conditions:
Soldering Iron Wave Soldering
Temperature
Soldering Time
300℃ Max.
3sec. Max.
(one time only)
Pre-heat
Pre-heat Time Solder
Wave Soldering Time
100℃ Max. 60 sec.
M
a
x
. 260℃ Max.
5
s
ec. Max.
Note: Excessive soldering temperature and / or time might result in deformation of the LED lens or catastrophic failure of the L
ED.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron
capacity
25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is
often started at the time of the hand solder.
5. Repairing
Repair should notbedoneafter theLEDshavebeen soldered. When repairingis unavoidable, a double-head soldering iron
should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by
repairing.
6. Caution in ESD
Static Electricity and surge damages the LED. It is recommended to use a wrist band or
anti-electrostatic glove when handling the LED. All devices, equipment and machinery must be properly grounded.
Art. Nr.
RND 135-00248
Distrelec Schweiz AG, Grabenstrasse 6, 8606 Nänikon, Switzerland, T [phone], [e-mail], distrelec.com