User guide

Configuration Module (ACC-02) Page 5 Version 1.00
8/31/2007
1 Features
Dipswitches are used for simplicity in changing the following settings:
o Step resolution from 2x to 256x microstepping
o Run Current
o Hold Current choices of 0%, 25%, 50%, and 100% of the run current
o Disable Power choice for holding in place or no power when disabling
the unit
o Step Sensing choice of reading from the rising or falling edge of each
step pulse input
o Direction Sensing choice of reading from the rising or falling edge of
the pulse for changing direction of rotation
o Damping modes to receive smoother motion
Simple connection with provided ribbon cable
Easy to use button for saving settings to unit
Easily enables the testing of different run and hold currents, and damping
modes
Choices of damping modes allows for the smoothest operation
Allows for compatibility of PLC’s, micrologix, and other modules that output
step pulses by allowing for a choice of reading the pulses on the rising or
falling edge of the step.
2 Dimensions
The configuration board is 1.10” wide and 3.10” long. The overall height of the
device is 0.45”.
3.10”
1.10”