User Guide
RMR-86 Mold Stain and Mildew Stain Remover: User Instructions
CAUTION: Use appropriate precautions when using RMR-86. Always pre-test surfaces before using our products. This is a
commercial-strength mold stain and mildew stain removing compound with a chlorine-like aroma. Please consult the SDS and
product label for specific instructions.
STORAGE: Inspect your package carefully to ensure contents were not damaged during shipment. Store RMR-86 in a cool,
ground level, dark area away from carpet, upholstery, metal, flooring, etc.; that may be damaged if leakage occurs after the fact.
If the container shows any signs of leakage, transfer solution to a clean plastic container that can be sealed properly. Store out
of reach of children and animals.
PERSONAL PROTECTIVE EQUIPMENT (PPE): Wearing full PPE is required when handling and applying RMR-86.
The minimum suit requirements are a hooded Tyvek or a chemical Poly Coated suit that is coated with a polyethylene film to
protect against splash/spray. (Shieldtech 55 Chemical Protection and Shieldtech 35 Liquid/Particulate Protection coveralls) Other
required materials include: latex gloves, and full face respirator with 3M 60923 P100 organic vapor/acid gas cartridge filter (or
equivalent).
APPLICATION INSTRUCTIONS:
• REQUIRED SAFETY PRECAUTIONS: Before starting application, make sure you’re wearing full PPE.
See "Personal Protective Equipment" section above for details.
• FOR ADDED SAFETY: Some areas, especially confined spaces like attics and crawl spaces, require added ventilation.
We strongly recommend using a fan with lay-flat ducting to add fresh makeup air to the workplace during application.
• For best results, use on surfaces with a minimum temperature of 50° F (10° C)
•
Shake the RMR-86 container well before application.
• Best applied using the RMR Solution’s commercial grade electric power sprayer or 1.5-gallon pump sprayer, or use a sprayer
that is rated for corrosive solutions, such as a plastic, garden -style pump sprayers. Avoid using sprayers with metal parts,
as they may corrode with use.
•
Spray affected area quickly, using wide sweeping motions, to cover entire area.
• Wait for a few moments and watch while RMR-86 eliminates the mold stains.
• If, after a few moments, evidence of the stain still remains, a second application of RMR-86 may be needed.
•
Once the stain has been removed to your satisfaction, we recommend using RMR Botanical to treat all surfaces after
RMR-
86 has been applied. It’s an excellent odor neutralizer & masking agent to remove any leftover odor from RMR-86.
PRODUCT CHARACTERISTICS:
•
RMR-86 is a ready-to-use product; dilution is NOT required.
• RMR-86 covers between 200-400 square feet per gallon. This can vary based on the severity of the affected area, as well as
how liberally the product is applied.
• RMR-86 works best when applied to dry surfaces at temperatures around room temperature. Frozen surfaces may be less
receptive to the product. RMR-86 may not be able to penetrate the particular building material affected if excess
moisture
content exists.
• RMR-86 can be corrosive if applied to the following materials: duct work, copper, metal, mechanicals, nail plates, steel,
aluminum, or any materials prone to corrosion. If RMR-86 is accidently applied to these materials, quickly wash area with
soap and water and wipe down with WD-40.
• Do not apply RMR-86 to fabrics.
• Always pre-test surfaces before using our products.
• Always rinse off surface, when only using RMR-86 by itself.
This product has a shelf life of 6 months or more.
Contact RMR Solutions, LLC at 866-822-8744
Revised 1/25/18