User Manual

User's Guide Fireface UFX II © RME
99
The playback from a storage device does not change the current sample rate. To match pitch
and speed, the sample rate has to be set manually to the correct value. Playback can be as-
signed to multiple outputs.
The UFX can play back externally recorded WAV files, as long as these have 16 or 24 bit reso-
lution.
The recording signal is taken before EQ and Dynamics, on both inputs and outputs. To record
with EQ/Dyn, activate REC on an output and route a signal processed by the input EQ/Dyn to
that output. The insert point of playback is at the same place.
The block diagram shows the signal flow for various situations, depending on the state of Loop-
back, EQ for Record and Play active. In the diagram Loopback and EQ are switched to off, but
a playback is active in the input.
Some extra notes that are worth to be pointed out again:
• The signal recorded by audio software is usually that from the input. But when the option
DSP – EQ for Record has been activated in the Settings dialog the software receives the
Play input signal – as soon as a playback is started from the USB device.
• On an output Echo/Reverb gets recorded. To add Echo/Reverb to a playback the playback
must be assigned to an input.
• A playback via USB can not be processed and immediately recorded again via DURec. Whi-
le the block diagram seems to present such functionality please remember that DURec can
do only one thing at a time – record or playback.